Connector cho Dewalt ToughCase+ (Dewalt ToughCase+ Connector)

With recent acquisitions of multiple Dewalt bits and the accompanying cases, I really liked the ability to stack the ToughCase+ onto each other. Unfortunately, you cannot stack the smaller size case directly onto the larger case in one layer. So I went searching for a piece that would allow me to connect them across the entire front but could not find one. A few hours of sizing and test printing later and now I have this part. 

I designed it to allow for support free printing but you will need to print two main body pieces and one connector. It is a snug fit on purpose but it will fit all the same.

Print:

2 Main Body

1 Connector