Tiếp tục dùng motor zin! (E3NG)

If you wish to upgrade your AB motor, you might encounter the same situation as I did. The original motor of the Ender 3 cannot be properly mounted on the Z-axis motor bracket. Therefore, I designed this new motor bracket to allow the original Ender 3 motor to be perfectly used on the Z-axis of the new printer.

I designed two versions: the original version and one that doesn't require supports. Both are very sturdy and function identically. You can choose which one to use based on appearance and printing time.

The screw length and fastening method are almost the same as the original design. The only difference is that each motor bracket requires two additional sets of M4 screws and T-nuts compared to the original version.