
Vòng cổ logo Skyrim (Skyrim logo necklace)
- Downloads
- 365
- Likes
- 91
- Views
- 1,542
- Remixes
- 0
- Comments
- 0
Files 2 59.1 MB
- Necklace_1776565660.stlSTL · 26.8 MB
- Necklace_ready_to_print_1776565664.stlSTL · 32.2 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #311994
- Category
- Trang Phục - Phụ Kiện
- Published
Description
A skyrim logo necklace!
Original model by: https://www.thingiverse.com/thing:3042456
I basically adapted it to a simple necklace, thicker, added proper support, an attachment point, topology fixes etc...
Printing!
I included my supported stl's as well as the sliced files for the anycubic photon S.
My print settings: (in use in the pre-sliced file)
Printer: Anycubic photon S
What to print?: 4 double sided skyrim necklaces at once
Time to print?: around 8 hours
Layer height: 0.02 mm
Quantity of resin used: around 20 mL
Type of resin: Anycubic Eco plant-based resin (macaroon pink and blue)
Printing temp: around 20C, the highest I could get at the time
Washing, Curing
I recommend removing the supports before curing. It's a bit more tedious with gloves and a mask, but they come off easier and there is less risk of damage.
also recommending to cure underwater, just tried with the last batch and they came out great.
Sanding
I started with 100 grit, then 150, 250, 600 grit.
Basically sand the supports marks until they are flat, then increase the grit to have a smooth finish.
Painting
I did two thin layers of black primer, then two layers of shiny chrome, short
/!\ WARNING /!\
I left the first three ones I printed on my desk in the sun before painting and they started to warp after 2-3 days. so maybe avoid leaving them in the sun before painting. (or cure them more).
Have fun :)
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 59.1 MB
- Largest file
- 32.2 MB












