Skip to main content
F3D
Khối kiểm tra trí tuệ WPPSI cho trẻ em 1

1 image

Giáo Dục

Khối kiểm tra trí tuệ WPPSI cho trẻ em

By Brian_240187

Downloads
31
Likes
6
Views
533

Files 3 3.9 MB

  • WPPSI_Block_x1_1766962778.gcodeGCODE · 764 KB
  • WPPSI_Block_x1_Lower_Tolerance_1766962779.gcodeGCODE · 569.5 KB
  • WPPSI_Block_x5_Lower_Tolerance_1766962780.gcodeGCODE · 2.6 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#31007
Category
Giáo Dục
Published

Description

These are similar to the blocks used in intelligence tests. 2.5cm. Children are shown a pattern on paper and asked to replicate the pattern with the blocks

Assembly

To make two blocks, print two copies of the STL in different colors. I believe white and red are common. The two halves fit together with friction. The snap connector isn't perfectly centered so rotating the halves 180* might give a better fit.

Print settings

  • Prusa MK3S+
  • 0.3mm draft
  • 1.75 mm PLA, Polyterra Matte White/Watermelon

Which file to print?

  • WPPSI Block x1 → start here, if too tight, then try the next
  • WPPSI Block x1 Lower Tolerance → snap connector is smaller, will provide less friction
  • WPPSI Block x5 Lower Tolerance → same as above but prints 5 copies

Why no STL/STEP file?

  • I did the cut and connector in PrusaSlicer which can't export this boolean operation correctly
  • If you want to reproduce, import a 2.5mm cube, cut in PrusaSlicer with snap connector that is 7.5mm (size) 7.5mm (depth)

Ideas for improvements

  • Add glue and clamp together for tighter fit
  • Rework model with a separate pin connector so that the mating faces can be printed face down and then glued together
  • Rounded corners

This is not an official block and may not match those used in standardized test

Read more Show less

Print spec

Formats
gcode
Model files
3
Total size
3.9 MB
Largest file
2.6 MB

0 comments

See all