Đế sàn mở rộng MagPul PMAG / Grip Extension

Extended Floorplate designed for 10rd MagPul 5.56 PMAGs. Offers more real estate to grab onto. Doesn't increase capacity. This model has an integrated plunger for easy disassembly and should be printed in place.

Versions available:

• v1: experimental version, not available anymore
• v2: Flat bottom; should be printed at an angle and needs supports under the entire 
  bottom surface (as shown in pictures)
• v3: Angled Bottom inspired by oldschool 20rd Mags; only needs supports under the plunger
• v4: experimental version, not available anymore
• v5: like v3 but a bit shorter and without rim
• v5LT: like v5 but with cutouts on both sides

Recommended Print Settings:

• Print in place
• Print orientation and supports as shown
• 4+ Perimeters
• 15%+ Infill
• 0.15mm Layer Height
• After the print is finished make sure the plunger moves freely

Local laws apply

Most of my creations are available as STEP files aswell

If you need anything, feel free to reach out! Questions/Suggestions/Criticism is highly appreciated. Happy Printing…