Ryobi Compact Router - Thanh dẫn cạnh trượt 6"

6" Sliding Edge Guide for Ryobi Compact Fixed-Base Router. Meant to attach to my 4" Square Base linked below. The combo works on most Ryobi Routers but the mode I use is #PCL424B

The guide allows you to route up to 6 inches from an edge and is adjustable!

Requirements:

• 4" Square Base for Ryobi Compact Router
• 4 10mm Long M5 Screws and M5 Washers

This attachment is screwed into the 4" Square Base linked above. It includes a 6" ruler measuring from the start of the edge, allowing you to fine-tune the distance you want to route from.

Threading the M5 screws through the Square Base the first time will take a bit of force, but this ensures the Sliding Edge Guide is firmly affixed. Slightly loosen each screw to allow the guide to slide back and forth, set the distance, then re-tighten the screws when you're ready to route! For very short distances, use the center holes present on the Square Base as your Slider attachment points.

Recommend printing in PETG for durability, but it will work fine with PLA. Print with a brim and preferably in an enclosure as PETG prints of this size are prone to warping. 100% infill recommended to adequately allow screw tightening without deformation.

Leave a comment if you would like this designed for a different brand of router!