Skip to main content
F3D
Giá đỡ lắp quạt mainboard cho Qidi Plus4 1

10 images

DIY

Giá đỡ lắp quạt mainboard cho Qidi Plus4

By SergejRiedel_515134

Downloads
141
Likes
22
Views
1,034

Files 7 1.7 MB

  • Main_part_1776496513.stepSTEP · 308.7 KB
  • Filter_cover_1776496514.stepSTEP · 24.8 KB
  • Main_part_1776496515.stlSTL · 284.6 KB
  • Filter_cover_1776496516.stlSTL · 36.2 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Eine verbesserte Lösung zur Kühlung der Hauptplatine des Druckers, bestehend aus einem Hauptteil und einem Deckel für die Filterseite. Für den Lüfter habe ich mich für dieses Modell entschieden: https://www.amazon.de/dp/B086SKG982?. Der ausgewählte Lüfter ist bürstenlos, leise und leistungsstark, und sowohl die Kabellänge als auch der Stecker passen perfekt.

Als Filter verwende ich einen Pollenfilter, da er fein genug ist, um Staub effektiv abzuhalten, und sich zudem leicht reinigen lässt. Der Filter kann einfach mit einem Staubsauger bei niedriger Leistung abgesaugt werden, ohne dass er ausgebaut werden muss. Sollte ein Austausch erforderlich sein, lässt sich der Filter unkompliziert wechseln, indem der Deckel geöffnet wird. Dieser Pollenfilter ist hier erhältlich:https://www.amazon.de/dp/B0CSP3MS17?ref=ppx_yo2ov_dt_b_fed_asin_title.

Zum Drucken des Hauptteils sind Stützen erforderlich.

An improved solution for cooling the printer's mainboard, consisting of a main part and a cover for the filter side. I chose this fan model: https://www.amazon.de/dp/B086SKG982?ref=ppx_yo2ov_dt_b_fed_asin_title&th=1. The selected fan is brushless, quiet, and powerful, and both the cable length and connector fit perfectly.

For the filter, I'm using a pollen filter, as it’s fine enough to effectively keep out dust and is easy to clean. The filter can be vacuumed with low power without needing to be removed. If it needs to be replaced, it’s easy to swap out by simply opening the cover. This pollen filter is available here: https://www.amazon.de/dp/B0CSP3MS17?ref=ppx_yo2ov_dt_b_fed_asin_title.

Supports are required for printing the main part.

Category: 3D Printing

Read more Show less

Print spec

Formats
3mff3dstepstl
Model files
7
Total size
1.7 MB
Largest file
544.7 KB

0 comments

See all