ENDER 3 NG v1.2 - Mount Toolhead Stealthburner

I completely remodelled the entire toolhead base to perfectly fit a Stealthburner toolhead.

This mount was designed to take up as little space as possible and e.g. still allow the use of the Z-Endstop / Sexbolt (a simple adapter plate would waste too much space, so the nozzle could not reach the Sexbolt at the back of the print bed). I attached a photo where the toolhead is at Y-min position (approx. 2mm behind the sexbolt).

This design has 2 built-in supports that must be removed. Print on the side where the switch will be installed (see Slicer Screenshot). Use same print settings as for all other E3NG parts.

Hardware required:

• 4 * VORON heat inserts for the front (M3 x 5 x 4)
• 4 * E3NG heat inserts for the back (M3 x 4 x 4.5)