Hộp Rugged Case: Insert Pinecil để ngang & ENGINEER SS-02

Horizontal Pinecil & ENGINEER SS-02 Insert for Rugged Case.

Needed an insert to hold both a Pinecil & ENGINEER SS-02 Solder sucker. Found two models:

1. A holder for a Pinecil (Horizontally) and it's cable.
2. A holder for a TS-100 and SS-02.

Put both files into fusion, measured the width needed to fit. Spliced both, reconnected them and measured again to have the same width that was needed. End of story :)

COMPATIBILITY

Since the Engineer SS-02 Solder Sucker is fairly large, It may not have enough clearence for some models. Please anticipate this.

Sometimes it's as simple as flipping one of the inserts for it to fit, otherwise might require seeking others. I will update the list below to those that I found to be compatible, as well as any I design that happen to be compatible.