
Đồ Chơi Khác
Bệ phóng cánh quạt dùng lò xo (Spring powered propeller launcher)
- Downloads
- 174
- Likes
- 52
- Views
- 1,678
- Remixes
- 0
- Comments
- 0
Files 14 22.2 MB
- Ratchet_wheel_1776456018.stlSTL · 6.3 KB
- Ratchet_1776456019.stlSTL · 40.6 KB
- Spring_1776456020.stlSTL · 495.8 KB
- Top_cover_1776456021.stlSTL · 216 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #306485
- Category
- Đồ Chơi Khác
- Published
- License
- Creative Commons — Attribution
Description
Printing:
- (red parts - C-TECH premium line PETG, black parts - Sunlu neat winding PLA)
- everything printed with 2 perimeters 10% lines (rectalinear) infill
- spring and ratchet should be printed with PETG
- propeller
- use HIPS or ABS if you can, printed on an ender 3 without an enclosure without issues
- print with random z seam to minimize weak spots
- light propeller offers better performance, at least with the PETG I used it broke after a few uses. HIPS WORKS (most likely ABS as well)
- heavy propeller works with PETG but offers significantly lower performance (4 turns = ~1.5 m)
- shaft printed with a brim for better first layer adhesion
Assembly:
- follow the video
- attaching the handle can be tricky, be sure to have tweezers on hand to help guide filament pins into their respective holes.
- white pins shown in the video are bits of filament:
- top and bottom plate connections - 4 x 20.6 mm (can be shortened after assembly)
- bottom plate, ratchet, handle connection - max 24.2 mm
- bottom plate, handle connection - 3 x max 15 mm
- glueing:
- check if everything works before glueing
- glue recommended - for best results use glue
- glue optional - not using glue should have minimal effect on function, don't use unless it's coming apart
Use:
- wind the spiring by the propeller holder
- (your results may differ, “Propeller light”)
- 3 turns = ~ 30 cm hop
- 3.5 turns = ~ 2 m
- 4 turns = wasn't able to measure, highest mostly reasonable amount
- 4.9 turns = most I was able to get, high chance of damage
- attach propeller
- push the trigger
- repeat
Print spec
- Formats
- gcodestl
- Model files
- 14
- Total size
- 22.2 MB
- Largest file
- 11 MB
0 comments
You may also like 12 models
See all-

-

-

-

-
New -

-

-

-

-

-
New -


