Tuần lộc Giáng Sinh - Prancer

This remix improves on a few areas that made printing the original design very difficult.

• feet have been made flat on the bottom and even, so deer stands in a more stable manner
• custom supports have been made more substantial to provide better support -- especially to the lifted front leg

For the other reindeer with all four feet on the ground, see yeg3d's design: https://www.thingiverse.com/thing:571949

DO NOT TWIST OFF SUPPORTS. Use a sharp Xacto knife or Dremel to remove the supports. Twisting off the supports will likely result in breakage of this very delicate model.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

0.16

Infill:

20%

Filament: Creality PLA White

Notes:

• I printed this at 145mm in height.
  I used 0.16mm layer height and a 0.4mm nozzle. I used Creality's white PLA filament. **DO NOT TWIST OFF SUPPORTS. Use a sharp Xacto knife or Dremel to remove the supports. Twisting off the supports will likely result in breakage of this very delicate model.**

Category: Decor