Cờ lê lắp đặt vòi Kohler dưới chậu rửa

I had a Moen faucet wrench that worked really well that came with those faucets. I used that design as a starting point to create a wrench specific to Kohler nut sizes.

Print details -

Printed with an outside brim because of how tall it is

2 perimeters with 20% Gyroid infill

PLA - I had a little deformation where the nut interfaced with the print after tightening. This is a one time use tool, so PLA worked great.

0.4mm layer height, but any layer height will work

Recommend printing with a 0.8mm nozzle to reduce print time.

How to use -

Slide faucet bracket over braided sink water line, stick brass nut in wrench, slide the braided sink water line through the center of the wrench, tighten nut and remove wrench.