Skip to main content
F3D
Giá gắn đèn pin Multiboard dạng Push Fit 1
Giá gắn đèn pin Multiboard dạng Push Fit 1
1 / 2

2 images

DIY

Giá gắn đèn pin Multiboard dạng Push Fit

By enahs

Downloads
106
Likes
17
Views
333
Download· 1 file · 22.8 KB· 22.8 KB

Files 1 22.8 KB

  • PegBoard_Flashlight_Snap_1776429786.stlSTL · 22.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#305336
Category
DIY
Published

Description

Snap the flashlight into place instead of having to slide into a full round ring. This works with all the Bellowhowell and knock off's. This is a remix from an OpenSCAD file, but I could not figure out how to mark it as a remix. I couldn't find it.

Anyway, this was printed with 4 walls and .2 layer height.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
22.8 KB
Largest file
22.8 KB

0 comments

See all

F3D uses essential cookies so the site works. Accept all also turns on marketing cookies for traffic and ad measurement; Essential only does not. You can change this in Cookie settings. Read the cookie policy