Mellanox ConnectX-2 Half-Height Bracket (Giá đỡ PCI)

This is a simple bracket that can be printed as a half-height bracket for single-port Mellanox ConnectX-2 PCI cards.

This is a remix of rasarmg's “PCI Bracket Generator” on Thingiverse, and is only a very small addition to it. If you need custom PCI brackets, check there.

Editing

Included is the OpenSCAD file for this, which is indeed very small tweaking on the file from rasarmg. It requires a copy of omdl, and I had used 0.6.1 in this file - newer versions may work, but it is probably simplest to grab the old release.

Please do not sell this model without contacting me first.

Printing

• Rafts: no
• Supports: yes, “on build plate only” should be sufficient.
• Infill: N/A
• Layer height: anything (0.2mm works fine)
• Material: PLA (PETG/ABS may also work, but there is a non-trivial bridge which would need support)