
DIY
Miếng lót khay để ly cho Toyota 4Runner (5th Gen)
- Downloads
- 210
- Likes
- 27
- Views
- 1,587
- Remixes
- 0
- Comments
- 0
Files 7 1.9 MB
- 4Runner_cup_holder_insert_-_front_2_-_print_at_100.5_pcnt_1776383116.stlSTL · 266 KB
- 4Runner_hollow_cup_holder_-_front_1_straight_up_-_print_at_100.5_pcnt_1776383116.stlSTL · 116.7 KB
- 4Runner_hollow_cup_holder_-_front_1_1776383117.stlSTL · 345.5 KB
- 4Runner_hollow_cup_holder_insert_-_front_tall_1776383118.stlSTL · 437 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #303863
- Category
- DIY
- Published
Description
Original model is great, but needs to be larger to fit. The model in this post is 101% which is a perfect fit. There are two versions of each cup holder, a solid and a hollow. Ideally should use PETG for heat resistance. I printed my first one in PLA, will see how it holds up this summer…
- Solid version can print without supports, any infill you desire, the more the better to make it heavy and not come out with your drink.
- I recommend upsizing barely, to 100.5%. This will wedge perfectly into the cup holder. Honestly works even better (and less effort) than the hollow version!
- The hollow version prints in two parts, can be filled with sand, clay, steel shot, pennies, etc.
- Print the base with standard settings, any infill (I did 100%).
- Print the cup holder upside down with 0% infill, 0 top layers to keep it open. After printing fill with weight of your choice and glue the bottom on.
- Hollow version must be printed with 2 walls only! My slicer defaulted to 3 walls, FYI.
- Added a base with thinner edge for 3 wall printing.
Either size will fit both cup holders, but the taller version has been stretched to fit the second cup holder; I never use a handle, so I did not make the cutout.
Print spec
- Formats
- stl
- Model files
- 7
- Total size
- 1.9 MB
- Largest file
- 437 KB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-
New -

-

-

-

-

-


