Bộ mô hình cây Giáng sinh

Set of trees and trunks that work interchangeably. The pieces thread together. The set includes 3 trunks and 5 trees:

Trunks

• Short Trunk
• Tall Trunk
• Tall Trunk - Textured

Trees

• Spiral Tree
• Lattice Tree
• Scalloped Tree
• Wavy Tree
• Diamond Tree

Check out the rest of my Christmas models here!

Print Settings

Trunks need no special settings. While the trees do not require any special settings, I recommend the following:

Spiral Tree

• 25% infill in the base and center threaded area - this adds weight to the bottom and keeps the tree stable after a trunk is added
• Manually move seams to the back side of each spiral. This will reduce curling of the leading edge.

Lattice Tree

• 25% infill in the base and center threaded area - this adds weight to the bottom and keeps the tree stable after a trunk is added

Scalloped Tree

• 25% infill in the base and center threaded area - this adds weight to the bottom and keeps the tree stable after a trunk is added
• 0% infill for the rest of the tree

Wavy Tree

• 25% infill in the base and center threaded area - this adds weight to the bottom and keeps the tree stable after a trunk is added
• 0% infill for the rest of the tree
• Use the Classic perimeter generator - Arachne leaves some unwanted edges

Diamond Tree

• 25% infill in the base and center threaded area - this adds weight to the bottom and keeps the tree stable after a trunk is added
• 0% infill for the rest of the tree

Buy Me A Coffee

The following filaments were used in the pictures above:

Spiral Tree

• Bambu Lab Matte Latte Brown PLA
• Prusament Simply Green PLA

Lattice Tree

• Bambu Lab Matte Latte Brown PLA
• Bambu Lab Matte Dark Green PLA

Scalloped Tree

• Bambu Lab Matte Latte Brown PLA
• Prusament Opal Green PLA

Wavy Tree

• Bambu Lab Matte Latte Brown PLA
• Inland Lutz Green PLA

Diamond Tree

• Bambu Lab Matte Latte Brown PLA
• Prusament Mystic Green PLA