Tấm đế gắn mạch RAK 19007

This mounting plate allows you to mount a RAK19007 board to an enclosure with the commonly found mesh plate as seen here: https://a.co/d/iQgPNPy. Use M4 or #8 size screws for mounting to the enclosure. For the board itself, the screws that come with the RAK19007 will work just fine.

PETG or ASA recommended if this will be used in an outside enclosure.

• .2 or .16 layer height works
• 30% infill is fine, although there are only a few infill layers so increasing this doesn't really change the print time much.