Đế giữ sạc Tesla (Tesla Charger Dock/Holder)

This charger dock holds onto and shelters a Tesla/NACS connector. It has no provision for coiling the cable. (If your cable is anchored overhead, there is no need to coil it.) Screws are concealed once it is installed.

It should be printed on its flat back, as delivered in the STL. No support material is needed.

To mount to a surface, screw two #8 screws into your wall with 2 inch vertical spacing. Do not screw them all the way in; leave about a quarter inch exposed for the dock to grab onto. Fit the two holes on the back of the dock over the screws. If the dock does not end up flush to the surface, turn the screws deeper into surface. Press the dock down to lock it into place. (This slides the screw heads along an internal wedge.) It should take some light pounding with a palm to firmly seat. If it seats too easily, it can come off easily; in this case, turn the screws deeper into the surface and try again.