Cây Thông Pixel Fidget Nhỏ Xinh

This little tree makes a great little gift, stocking stuffer or present topper 🌲 Print more than one and make a mini forest 🌲🌲🌲

Dimensions of tree (assembled): 2 ½ in x 2 ¼ in x 1 in.

3D Printing Instructions:
PLA Basic recommended*
Layer Height 0.2mm
Infill 10-15%
Supports needed under tab at end of tree

*Basic PLA is the best for this print. I don’t recommend PLA Silk or PLA Matte filaments. This is detailed (on the inside) and the tolerances are small.  I printed several of these in these three types of filaments and Basic PLA always printed the best and had smoother “movement” when done.

To assemble, slide the trunk over the peg at the bottom of the tree. (You can add some super glue if you'd like:)

Have fun printing! 😊