Skip to main content
F3D
Bộ khung (Enclosure) dành cho máy in 3D Flashforge Adventur… 1

3 images

Large file collection Máy In 3D

Bộ khung (Enclosure) dành cho máy in 3D Flashforge Adventurer 5M

Remix of Vỏ Máy In Flashforge Adventurer 5M By Allar3D_1204273

By Zdendys

Downloads
962
Likes
129
Views
8,919

Files 24 4.1 MB

  • A1_1_1776289372.stlSTL · 60.7 KB
  • A1_2_1776289373.stlSTL · 75.2 KB
  • A2_1_1776289374.stlSTL · 70.7 KB
  • A2_2_1776289375.stlSTL · 45.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Remix of the model from the manufacturer. It uses parts from the original kit supplied by the manufacturer.

Differences from original for full functionality:
M3x6 mm bolt 3 pieces and M3 nut  5 pieces are needed. M3x30 mm bolt 2 pieces for hinge, or you can use original hinge with no bolts.

Attention!!! The original plexiglass needs to be cut from the bottom edge by 5mm!!! In the model, it is generally moved lower so that it does not hit the display, which is caught in the original brackets.

What is modified in the model compared to the original:

The top cover is thinner and lowered by 14mm.

The side covers are split.

The front plexiglass is lower by 5mm and therefore shortened from the bottom edge by 5mm.

It uses the original positioning of the display including its brackets.

The hinges use an M3x30 screw.

It uses the original coil holder.

I printed this complete under 800g of filament. Everything is printed from PETG. Supports are needed in a few places. Models A-D are printed flat on the bed.

Czech:

Remix modelu od výrobce. Využívá díly z původni kitu dodávaného výrobcem.

Rozdíly oproti originálu pro plnou funkčnost:
Je potřeba šroub M3x6 mm 3kusy a matice M3 5 kusů. Šroub M3 x 30 mm 2x pro panty. Nebo můžete použít původní panty bez šroubů.

Pozor!!! Původní plexisklo je potřeba ze spodní hrany o 5mm seříznout!!! V modelu je celkově posunuté níž aby nenaráželo o display, který je uchyven v původních držácích.

Co je v modelu upraveno oproti originálu:

Horní kryt je tenčí a snížený o 14mm.

Boční kryty jsou dělené.

Přední plexisklo je níže o 5mm a tím pádem i zkráceno ze spodní hrany o 5mm.

Využívá původní umístění displeje včetně jeho držáků.

Panty využívají šroub M3x30.

Využívá originální držák cívky.

Komplet jsem to vytiskl pod 800g filamentu. Vše je tištěno z PETG. Na pár místech jsou potřeba podpěry. Modely A-D se tisknou plocho na podložku.

Read more Show less

Print spec

Formats
stl
Model files
24
Total size
4.1 MB
Largest file
886.1 KB

0 comments

See all