Ván trượt tuyết mini - Finger Board

Small Snowboard.  I made this for a craft project my wife made. She crafted some wool figurines and I made some chairlift chairs and this snowboard for her. This can also be used as a finger snowboard

I made this with PLA.

Dip the ends in hot water for a few seconds to form the shovels (bends) on the ends. I just bent them against my table top.

The 3MF file has the color change included. The color change happens after the 1.25mm layer. Color 1 up to 1.25mm, color 2 above 1.40mm.