Khuôn đúc silicone gag (có khe thở)

This is mold for creating a silicon gag. When printing use 0.1mm layer height, and enable ironing for bests results. I used 30A platinum silicone, 40A works too. 

Mold parts are designed with no clearances, and front end rear pipe parts even overlap a bit (1mm). Some sandpaper may be required, when you assemble it after printing.

If you need different size - just scale everything uniformly, and it should work.

Gag weights ~50g, so use ~80g of silicone to be sure.

Model update 2024-12-16

Mold is exported as separate files. Also hole diameter for pouring in silicone increased from 7 to 9 mm