Sovol SV08 Y End Stop

From respect to our members this file it will be available in the first week for members only and next week it will be free for all. thanks for understanding. 

The parts are already oriented for better print and no need for support. 
If you will ever enclose the 3d printer we recommend ABS if not PLA can do the job!

This is a PRES FIT and the tolerances are like all out designs Tighter than your EX 

here is a fast tolerance test https://www.printables.com/model/910484-fast-tolerance-test

From the Printer CFG you need to edit the endstop_pin from  tmc2209_stepper_y: virtual_endstop  to the used pin PE12 if you replace the Presure sensor or PC8 if you will use the 2 pins from the Expansion2 port usually used for the Knob Display

and you will need to comment /  disable the last 2 lines fom the [tmc2209 stepper_y]

[stepper_y]
step_pin: PB8
dir_pin: !PB6
enable_pin: !PB9
rotation_distance: 40         
microsteps: 16                
full_steps_per_rotation:200   
endstop_pin: PE12  #PC8  # tmc2209_stepper_y: virtual_endstop              
position_min: 0               
position_endstop: 364         
position_max: 364            
homing_speed: 30              
homing_retract_dist: 0        
homing_positive_dir:  true     
#--------------------------------------------------------------------
[tmc2209 stepper_y]
uart_pin: PB7
interpolate: True             
run_current: 1.1              
#hold_current: 1.5             
sense_resistor: 0.150         
stealthchop_threshold: 0      
uart_address:3
#driver_sgthrs: 65
#diag_pin: PE13 

boom 

M3 Screw kits  https://s.click.aliexpress.com/e/_DBdNTVD

1x 3d printer microswitch for X end-stop https://s.click.aliexpress.com/e/_olerw8X

2x M3x4mm long 4,5 OD heat set insert  https://s.click.aliexpress.com/e/_Dn50b1h