Ống thổi gió 5015 cho Ender 3 V3 SE

I printed 20mm, 3 walls and PETG. You need at least 2 M3X20 pan head screws to secure and stabilize the blower into the part. I used 4 because I wanted they super tight :)

I managed to print the left one without any supports and for the right one only on the extreme overhang, but I did it with good cooling using prototypes of the same duct, added images for good visualization :)

Hope you like it. These have the best airflow I tested so far for ender 3 v3 se with 5015 blowers. Thanks the author for the original model.

On a later date I will try to put honeycomb walls on these to improve aesthetics even more. Will run some tests before to ensure this doesn't harm efficiency.