Vuvuzela Cứng Cáp, In Nhanh Gồm 3 Phần

Made a stronger and easier to print version. Ideally it's glued together with a solvent weld like Weld-on 16. For middle and top files, place the wider piece on the print bed. For the bottom file place the mouthpiece down. I used a 5mm outer brim because the pieces are tall with little contact with the bed. I used inside supports for the bottom and middle pieces. On my Prusa i3 MK3 I was able to print two of each of the parts (two bottoms, middles, and tops) in a go, and get two complete "instruments" in about 4 hours.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

**Rafts:**

No

Supports:

Yes

**Filament:** Any PLA

Category: Music