Chân đế cho Fritz!DECT 440

The stand for the switch and display Fritz!DECT 440 by avm is shown in photo No. 1. 

Simply place the display on the stand and you are done! The display resting on the stand is shown in photo No. 2. 

The stand may optionally be used with magnets to make the display sitting on the stand more firmly. The magnets are friction fitted into the two slots. Photo No. 3 shows a magnet resting in a slit. The two magnets have to have dimensions of 10 mm x 2 mm to firmly fit into the slits. The slit is 8 mm deep. Pelase note, that the stand also works well without any magnets. 

We used PrusaSlicer 2.8.1 for slicing and Prusa i3 MK3S+ for printing. The settings were:

• Material: PLA, blend peral white from Prusa.
• Layer Height: 0.2mm.
• Orientation: Place the stand one of the narrow sides with a slit. Photo No 4 shows this orientation.
• We used supports of type ‘Snug’. Photo No. 4 shows the printed stand and the supports while still attached to the printing plate.
• We suppressed the generation of supports within the downward facing slit. For doing so, you may right click the object and select ‘Add support blocker’ to generate and position a box in which PrusaSlicer will not generate any supports.
• Infill: 15%