Skip to main content
F3D
Cần gạt công tắc đèn phong cách Minecraft (Dạng phẳng) 1

4 images

Mỹ Thuật

Cần gạt công tắc đèn phong cách Minecraft (Dạng phẳng)

Remix of Minecraft Switch Geared Remix - Nắp công tắc phong cách Minecraft By BobbyBass

By MAB_1719554

Downloads
622
Likes
257
Views
6,778

Files 13 3.7 MB

  • COVER-PLATE_1776187001.stlSTL · 94.6 KB
  • KEY_1776187002.stlSTL · 21.8 KB
  • BASE-PLATE_1776187003.stlSTL · 77.4 KB
  • RAIL-GEAR_1776187004.stlSTL · 13.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

The installation of this is fairly straight forward but you'll need to use slightly longer screws than the ones that are currently attaching your light switch cover. 6-32 x 1 inch machine screws with a round head should work fine. 

  1. Slide the “RAIL-GEAR” into the “BASE-PLATE”.
  2. Insert the “KEY” in the “RAIL-GEAR”, it should fit snuggly into it.
  3. Remove the screws from the existing light switch cover. (You can either keep the cover in place or remove it.)
  4. Screw the “BASE-PLATE” over the light switch. You'll need to slide the “RAIL-GEAR” up or down to gain access to the screws. Validate that the “RAIL-GEAR” still slides easily, if not try loosening up the screws a little bit. 
  5.  Install the “COVER-PLATE” over the “BASE-PLATE”.
  6. Glue the 3 parts for the lever together (Gear/Handle/Wood)
  7. To install the lever, place “RAIL-GEAR” and Lever as shown below then use the Pin and Clip to secure it in place.

It works for this type of switch:

Here’s the list of filaments I used to make this:

  • Bambu PLA Sparkle Slate Grey
  • Bambu PLA Sparkle Onyx Black
  • Polylite PLA Steel Grey
  • Bambu PLA Matte Dark Brown

Read more Show less

Print spec

Formats
stepstl
Model files
13
Total size
3.7 MB
Largest file
1.1 MB

0 comments

See all