Skip to main content
F3D
Móc khóa hình thanh cá tẩm bột (Fish finger keychain) 1

2 images

Mỹ Thuật

Móc khóa hình thanh cá tẩm bột (Fish finger keychain)

By jk_printer

Downloads
1
Views
85

Files 5 4.7 MB

  • Fish_Finger_Key_Chain_Fish_D4.5_v1.1_1775696096.stlSTL · 1.6 MB
  • Fish_Finger_Key_Chain_Top_Shell_D4.5_v1.0_1775696098.stlSTL · 541.1 KB
  • Fish_Finger_Key_Chain_Fish_D3.5_v1.1_1775696099.stlSTL · 1.5 MB
  • Fish_Finger_Key_Chain_Top_Shell_D3.5_v1.0_1775696101.stlSTL · 540.9 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

A key chain in the form of a fish finger :D  I don't know if the world needed this, but now it exists! It's roughly the size of the real thing and available with two bore diameters (3.5 and 4.5 mm) for different key rings. The cap is held in place with small clips, so tolerances matter.

Print settings

  • Layer height 0.2 mm (you could try 0.24 mm for the cap and top shell to see if the surface roughness looks even more convincing)

  • Line width 0.42 mm

  • 3 wall lines

  • Fuzzy Skin recommended for cap and top part, but not for the fish

    • Fuzzy Skin only on the outside

    • Fuzzy Skin thickness 0.3 mm,

    • Fuzzy Skin density 1.2 1/mm

    • If you use Orca Slicer, you may want to try other patterns like Perlin noise

  • 4-5 top & bottom layers

  • Supports not required

Approximate print time @ 60 mm/s: Cap/Top 0:30 h each, Fish 1:05 h

Read more Show less

Print spec

Formats
stl
Model files
5
Total size
4.7 MB
Largest file
1.6 MB

0 comments

See all