
Honeycomb Storage Wall Filler - Bản Remix Solidworks
Remix of Tường lưu trữ Honeycomb By RostaP
- Downloads
- 0
- Likes
- 0
- Views
- 74
- Remixes
- 1
- Comments
- 0
Files 10 1.1 MB
- hsw_filler_clone_1775628430.sldprtSLDPRT · 455.4 KB
- hsw_filler_sw_corner_1775628431.3mf3MF · 22.6 KB
- hsw_filler_sw_full_1775628432.3mf3MF · 26.3 KB
- hsw_filler_sw_half_1775628433.3mf3MF · 24.1 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #291515
- Category
- Đồ Gia Dụng
- Published
Description
I remade these parts in Solidworks to allow me to make some more complex assemblies for my own HSW project but these files could also help others if needed. I also exported the individual pieces to STEP to make customization in other pieces of software a bit easier.
As mentioned from the original creator, these will use more filament than you think and they are entirely aesthetic. I had a bunch of old filament laying around that I used for this project.
Important note: the half pieces are 'true' half pieces dimensionally as the border I made for my project was using exact halves of the hexagons. I later found out most borders do not use true halves. It is not one to one dimensionally from the original design and I may upload the original half in future.
Print spec
- Formats
- 3mfbgcodesldprtstep
- Model files
- 10
- Total size
- 1.1 MB
- Largest file
- 455.4 KB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-

-

-
New -

-



