Giá Đỡ Lọ Sơn 32mm Cho Hệ Thống Multiboard

Description:

This is a paint bottle holder designed for the Multiboard system here:

https://www.multiboard.io/

There are several types out there but none seemed to quite fit what I needed.

The design uses the small thread bolt available here:

https://thangs.com/designer/Multiboard/3d-model/Small%20Thread%20-%20Multipoint-1123334

“Small Thread – Multipoint”

It is suitable for various bottle sizes up to 26.5mm diameter which includes Army Paint, X Arty, Vallejo and so on but NOT Citadel!

You can evenly stack the system vertically 

Very easy to install and can be removed and moved at a later date without damage.

Provides an excellent visual layout to be able to easily view paint colours on all displayed bottles. However as a side affect this unfortunately does mean you will need more space than some other systems.

MEDIUM 26.5mm dia Bottle Version available here:

https://www.printables.com/model/1374854-multiboard-medium-265-dia-paint-bottle-holder-suit

CITADEL 33.5mm dia Bottle Version available here:

https://www.printables.com/model/1399904-multiboard-citadel-335-dia-paint-bottle-holder

35mm dia LARGE Bottle Version available here:

https://www.printables.com/model/1388077-multiboard-large-35-dia-paint-bottle-holder

37.5mm dia LARGE PLUS Bottle Version available here:

https://www.printables.com/model/1398933-multiboard-large-plus-375-dia-paint-bottle-holder

200ml, EXTRA LARGE 50mm dia Bottle Version now available here:

https://www.printables.com/model/1378916-multiboard-xl-505-dia-200ml-paint-bottle-holder-su

Installation Pointers:

You will need at least two small thread multipoint bolts/screws, link above. On my install I just used two. If your bottles are tight in the holders then you might want to put a couple more in.

I installed all my bolts finger tight.

The bolts locate in the small diamonds which are built into the Multiboard.

The Holders are labelled “32", “A-H” A is the left most holder. If you are wanting to place them together in a line as shown you should start with “A”, then “B” and so on. Note that “A” will not connect to “D”. 

If anyone needs more horizontal holders let me know.

There is a small overlap so if you want them tight together fit A first, then B (etc.).

If the holder is correctly fitted the diamond just above the top of the holder back will be fully exposed – see pics.

To stack vertically - see the pics.

Printing:

Multiboard recommend 3 wall loops.

No supports are needed