Giá đỡ cho xe đẩy Golf (Golf Cart Mount Bracket)

Why I made this:

The Clicgear adapter did not fit on my Rovic, so needed to whip something up to be able to use the Scrubi Christmas present I was given.  This adapter will fit on most posts on the Rovic cart.   The locking mechanism is ok, but needs a little more work, will update with next version, but after a few uses it's pretty solid.

Features:

• Allows for attachment on more locations for my Rovic cart

Customization:

• Increase structural integrity for a tighter bolt

• Increase the size of the post Boolean for better connection

Print Settings

• Material: I printed this in PLA (solely because I can't get PETG to work on my printer) I would suggest PETG or ASA especially if you are golfing in super hot temps.

• Infill: 40% - 60% (Cubic or Gyroid for strength).

• Wall Loops: 4 - 6 (This is where the strength comes from, not the infill).

• Layer Height: 0.2mm or 0.28mm (Strength is more important than detail here).  I printed on the Ender 3 neo with 0.28 first layer and the remaining 0.2.

• Supports:  Yes, don't orient for minimal supports.