Giá treo đèn pin Costco Infinity X1

This is to hold 2 different versions of a flashlight that were bought at Costco. Infinity X1 5000 and 3500.

My wife didn't like me having the flashlight set on the table by the front door, so I was forced to innovate. 
I made V1 for myself, and it worked great, and I would have stopped there, but my dad also wanted some for his RV because he had the same light. V1 even worked in the motorhome, but when mounted on the inside of a door, it would eventually fall off under use. To solve this, I went through several useful versions and have left them all here because each is good in its own way. V5 really grabs the flashlight and has a slight detent top and bottom to hold it in place even under vigorous shaking, but it is also easily removed when grabbed by the top or bottom.

Printing Suggestions:

• 4 Walls (2 or 3 may be OK)

• 20% infil

• PETG for a little give (PLA may be fine, have not tested)

Mine is printed with Prusament PETG Ultraglow Green