
Hộp đập espresso với trục TPU+PETG
Remix of Hộp gõ espresso với chốt 20mm và đường kính 120mm By thenickdude
- Downloads
- 105
- Likes
- 20
- Views
- 828
- Remixes
- 0
- Comments
- 2
Files 3 629.6 KB
- Dowel_Flex_1766149341.stlSTL · 55.7 KB
- Dowel_Rigid_1766149342.stlSTL · 26.8 KB
- Knock_Box_TPU_PETG_Dowel_1766149343.f3dF3D · 547 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #28718
- Category
- Đồ Gia Dụng
- Published
- License
- Creative Commons — Attribution
Description
I liked @thenickdude's version of @deLamorDesign's knock box, but I didn't have any dowels on hand so I made my own.
I also wanted the dowel to have a rubber coating, like other knock boxes I've used, so I made a two-part design with a rigid inside and a 1.2mm thick TPU outside.
There is 0 tolerance built into the design as it's better to be a little too tight than too loose, so I had to use a little sandpaper to clean up the knock box holes for this to fit. If your printer is better calibrated than mine, you might not need that.
Print spec
- Formats
- f3dstl
- Model files
- 3
- Total size
- 629.6 KB
- Largest file
- 547 KB
2 comments
You may also like 12 models
See all-

-

-

-
New -

-
New -

-

-

-

-
New -


