Lightsaber - Warden (Kiếm Ánh Sáng)

My 4th saber, the second to use an inner core, and the first to have an alignment pin on the core to make sure all of the pieces sit where they are supposed to. This one is more complicated so I do not recommend changing the alignment of the pieces. A lot of trial and error went into getting them just right so they printed properly. The tolerances are tight, like all of my models, so be sure your filament is dry. Some of the smaller inlay pieces may require a small spot of glue. If you like my work you can find more over on Makerworld under the same name.