Đèn bàn Articulating C-Clamp dễ in

This is just a simple lamp I created for my desk. It utilizes my C-Clamp I designed. It has 4 elbow joints and 1 ball joint so you're able to direct the light to the left or right rather than just up and down. All parts are in the correct position for printing. Minimal support required check below.  The lamp shade is close fitting, I would only use led bulbs in this. Do not use incandescent bulbs they can get hot which may result in melting or fire.

__________________________________________________________________________________________________________________

***If you need help assembling the C-Clamp, check my other listing it may help you, if that's not helpful feel free to reach out to me. I'd love to see some makes and get some feedback as well. ***

__________________________________________________________________________________________________________________

Hardware:

• M10-¾" For connecting the Elbows (2 washers and a nut for each bolt) 4 bolts total.
• M10-2" For the ball joint. (1 nut for the bolt) 1 bolts total.
• 8ft replacement lamp cord (available at Walmart) Picture below.
• 3-way lamp socket (available at Walmart) Picture Below.

__________________________________________________________________________________________________________________

You can print this with minimal support, but I do recommend support for these areas. 

     -All parts are already orientated into the correct printing position.

__________________________________________________________________________________________________________________

The housing and the lamp shade are designed for the particular lamp socket pictured above. they will slide onto the socket snug and fit. So, no glue is needed to keep them on. I do recommend glueing all rods into the joints. You will need to glue the base adapter to the base.

-Hope everyone enjoys.