Móc treo tạp dề / áo khoác hiện đại

Simple, clean, modern hook. Designed to simply snap snug on to a US standard 1" drywall screw. I simply install the screws into the hook align and press into drywall to mark, screw the screws in and re-hang the hook.

Print instructions

Printed with default PrusaSlicer settings in PLA, Supports Everywhere, 20% infill.

I recommend placing the print in the slicer on the non screw hole surface as it defaults. This improves the quality of all visible sides.

A small screw driver can easily assist in removing the screw hole and notch infill. I've found it easiest if you push in the screw hole perpendicular to notch to lift the circle infill then from the notch toward the circle to pull out the remainder.