Mô hình nhà mái đôi thu nhỏ

This is my first attempt at 3D sculpting, so it's not remotely perfect.

You can see my unsteady pulse, but I think it gives it some extra personality (at least I hope so 😅).

It was done in Nomad Sculp for the Ipad, which is a great software that, at least for now, I'm not very good at.

Print Settings

Printed in PLA, at 4160% scale, no supports or rafts, at 0.2mm resolution and 15% infill.

The model itself is quite small, so as you can see from the settings above, it is scaled up.

For easy printing, you may want to turn on the "Make Overhang Printable" option  in Cura and set it to around 70.0°.

The difference can be seen in the following images:

"Make Overhang Printable" OFF:

"Make Overhang Printable" ON: