Khối lập phương hiệu chuẩn Monolith (Monolith calibration cube)

Printable calibration cube designed and taken inspiration from the Monolith gantry project

If the calibrations below come out perfect, you are ready to start your monolith gantry!

Features:
- Bottom hole fit F695/F698 bearing and the cap should close
- Top hole fit (F)695/(F)698 bearing
- Recessed logo is 2.5mm deep, allows checking for grubscrew length
- Top and bottom of flat side used to check ringing and vfa
- Bridging test in the center
- 20-30 deg overhangs on the logo
- Hidden easter egg

Recommended print settings:
- Per monolith recommendation

Recommended materials:
 - Per monolith recommendation

Changelog:

Official release

Changes

v2

26th Feb 2025

First official release