
Inchworm Automaton - Núm xoay thay thế
Remix of Mô hình Automaton Sâu Bướm Inchworm By Dawlight_1954975
- Downloads
- 117
- Likes
- 7
- Views
- 403
- Remixes
- 0
- Comments
- 0
Files 4 7.6 MB
- inchworm_knob-v1_1775122630.stlSTL · 561.5 KB
- inchworm_knob-v2_1775122632.stlSTL · 3.7 MB
- knob-v2_0.2mm_PLA_30m_1775122633.gcodeGCODE · 1.8 MB
- knob-v1_0.2mm_PLA_28m_1775122635.gcodeGCODE · 1.6 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #281743
- Category
- Đồ Chơi Khác
- Published
Description
The available crank for the automaton often fell off or was difficult to spin well. It also broke once when handled roughly. I created this to be a little easier to print and eliminate smaller aspects that can break.
There are two versions that are effectively the same. The edge treatment is slightly different, and the v2 has better chamfers. The fit for both is meant to be reasonably tight, so you may need to shrink the x-y somewhat if you can't get it to fit (or use something to un-biggen the part that inserts).
The dial should not be larger in the x-y dimensions as it is relatively close to the moving worm.
Print Settings
Standard settings are fine. There's nothing special going on here.
Print spec
- Formats
- gcodestl
- Model files
- 4
- Total size
- 7.6 MB
- Largest file
- 3.7 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-

-

-

-
New -


