Hardware Free BCAR - Tương thích Ex

Use all the support parts from the original, but print this version of the body.  There are a number of Rev 2 EX BCAR mounts now for various blasters.  Now you can have a fully 3d printable BCAR.  

EDIT - uploaded a better version.  Original one was one of the very first files i ever remixed so the alignment was not the best.  Now it should be much better.  Leaving the old one so you can compare.

EDIT 3/19/2024 - uploaded one with a bigger ID (16mm) compared to original's 13.5 mm, working on something else that this will support.  No change to where the washers contact.

Print instructions:

.2 or .16 mm layer height, 25% gyroid infill, no supports, you will probably want a brim.