Bản Mod Tay Ga Kiểu Vặn "Quarter" Cho Ninebot Max

DO NOT REPOST ANY PART OF THIS MODEL WITHOUT PROPER ATTRIBUTION! FOLLOW THE CREATIVE COMMONS ATTRIBUTION NON-COMMERCIAL SHARE-ALIKE LICENSE TERMS! USE THE REMIX BUTTON!

This was more of an experiment to see if I could create such a thing, and I think it turned out pretty well. Be warned however, I personally found it not to be very ergonomic for longer rides. It does look and feel badass though!

Hardware needed:

• M2 nuts (7x)
• M2x12 (6x)
• M2x16 (1x)

Assembly/Attachment:

1. Press fit 7x M2 nuts into the cutouts of the throttle interface part
2. Slide off your right stock grip
3. Use an M3 allen wrench to remove the grip stop from the handlebar
4. Slide the throttle interface part on with the tab facing the thumb throttle
5. Add the small washer part after the throttle interface
6. Reattach the grip stop using the setscrew
7. Slide stock grip back on
8. Slide the main twist grip piece over the stock grip and align screw holes
9. Insert and tighten the longer M2 screw on the bottom most screw hole below the thumb throttle, this longer screw locks the whole thing in place from rotating the other way
10. Insert the remaining 6x screws and tighten

Test it out! It should rotate freely. You can adjust the position of the thumb throttle on the ninebot max with an allen wrench if needed, though I modeled this after the stock placement.