Adapter pin Dewalt sang dụng cụ Milwaukee (Dewalt Battery to Milwaukee Tools adaptor)

Cordless tool battery adapter.

Dewalt Battery to Milwaukee skin tools

Extra hardware

• 6mm male spade connector x2
• wire
• female fuse terminal x3
• M3 x10mm bolt & Hex nut x2
• 470k resistor
• spring (0.5mm, 35mm, 5mm) a retractable pen spring will probably work too

Prep spade connectors like this, flatten out the shoulders if you can

Basic assembly procedure

• remove spade terminal sheath and crimp to wires, flatten it out
• install spring and side buttons into top
• install wired spade terminals into base and thread into the top
• bring top an bottom together, pulling wires through as you go
• use nuts and bolts to bind the top and bottom together
• trim wires appropriately to allow female terminals to fit into their slots
• crimp female terminals, remembering to include the resistor into the positive terminal
• push terminals into place, I used hot glue to cover up the resistor

Reach out if you need further clarification

 EDIT 28-3-25

Added V2 of the top that moves the female terminals a bit closer (4mm) to the male ones

If you like this model, please throw me a like.  Designing the models is time, filament and coffee consuming. If you want to support my work buy me a coffee (PayPal). Thanks!