Case Raspberry Pi 5 hỗ trợ Pimoroni NVME Base

Remix of Vỏ Raspberry Pi 5 (snap fit) By pyrho

By LUC4R4T0R

Downloads: 2,134
Likes: 198
Views: 10,966
Remixes: 0
Comments: 0

Download all (.zip)· 7 files · 511.2 KB· 511.2 KB

Files 7 511.2 KB

top_1776780468.3mf3MF · 102 KB
bottom_1776780470.3mf3MF · 23.8 KB
bottom_duo_1776780471.3mf3MF · 24.6 KB
top_ribbon_1776780472.3mf3MF · 107.5 KB
top_gpio_1776780473.3mf3MF · 105.1 KB
top_ribbon_gpio_1776780475.3mf3MF · 110.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID: #278671
Category: DIY
Published: 04/21/2026
License: Creative Commons — Attribution — Share Alike
Tags: raspberrypi
raspberrypi5
nvme
pi5
pimoroni
pi5case
nvmessd
nvmebase

Show more tags Show fewer tags

Description

I recently received the NVME Base by Pimoroni for my Raspberry Pi 5. I noticed that there are only a few cases which accommodate it. I was sure that I could remix a nice case to change that. Here it is…

Update: Added different bottom shell for NVMe Base Duo (long term usage not tested)
A Pimoroni NVMe Base Duo was kindly provided by RaspberryStore.nl , as a reference.

#HowTo Print

Place the halves of the case with their largest flat side facing towards the print-bed. The material is your choice. I simply used PLA. I used 0.15mm Layers but everything ≤0.2mm should work.

#HowTo Assemble

Install the NVME Base to your Pi by following Pimoroni's installation-instructions (https://youtu.be/odG7FbptgWQ).
Insert the assembly carefully into the bottom shell with the NVME-base facing down and the micro-SD-slot facing its designated opening.
Snap fit the top and you are done! 🎉