NODE - Kẹp giữ lớp lót giỏ đựng đồ 01

NODE - Basket Liner Retention Clip 01

A simple, purpose-built clip designed to keep fabric liners securely in place on woven or wire laundry baskets.

This was created to solve a common frustration—liners slipping, collapsing, or shifting during use—without resorting to bulky or over-aggressive clips. The geometry provides reliable retention while remaining easy to install and remove.

---

### Features

* Purpose-built for basket liner retention (not a generic clip)

* Clean, low-profile form that doesn’t interfere with use

* Balanced flex for secure hold without excessive force

* Optimized for support-free printing

* Consistent performance with standard PLA or PETG

---

### Fit & Use

* Designed for basket rims approximately 0.38" wide [10 mm]

* Works best with typical fabric liners (cotton/poly blends)

* Install by pressing over rim and fabric—no tools required

Note: Fit will vary depending on basket geometry and material thickness. Scale slightly if needed for your specific application.

---

### Print Recommendations

* Orientation: Print flat as shown

* Layer height: 0.20 mm or 0.24 mm

* Walls: 3+ (4 gives you a solid infill and prints slightly faster, my recommendation)

* Infill: 10–15% (not critical). Honestly at this size, solid is perfectly fine.

* Material: PETG (suggested for durability) or PLA (general use)

No supports required.

---

### Design Notes

This is a straightforward, utility-focused design—intended to solve a specific problem cleanly and reliably. No excess features, no unnecessary complexity.

---

### Attribution

Part of the Engineered Modern (EM) collection

Thoughtfully designed. Carefully crafted.