
Kệ để đồ (Hardware rack) đa tầng có thể chồng lên nhau
- Downloads
- 15
- Likes
- 2
- Views
- 98
- Remixes
- 0
- Comments
- 0
Files 3 472.9 KB
- Rack_insert_1775901583.3mf3MF · 250.8 KB
- rack_1775901586.stlSTL · 189.2 KB
- rack_bar_1775901587.stlSTL · 32.9 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #277529
- Category
- DIY
- Published
- License
- Creative Commons — Public Domain
Description
This is my first model from the ground up, I wanted a more secure and bigger rack than what was available online. Its 250mm tall, 150mm wide, and 268 mm long when assembled,
Hardware is needed for stacking racks together just a M3 nuts and M3x10 bolt on all four corners, use a drill to get it to slide thru.
The spreader bars are a little fragile and are a bit of a tight fit, but push in and slide down. The racks just slot in to the bars
Let me know if any changes should be made to improve it
Note I used my bambu p1s to print, idk if this will work on a small printer as the p1s has 256x256 build plate, It might need to be scaled down to be made
Print spec
- Formats
- 3mfstl
- Model files
- 3
- Total size
- 472.9 KB
- Largest file
- 250.8 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-

-
New -

-

-

