Giá Treo AMS Light Cho Hệ Thống RepRack

I give thanks to RepKord for the Reprack System

 This is an AMS Light Hanger designed around the RepRack. It was custom made for my personal setup. When I set the infill and outer layer, I went “OVER KILL” As a personal preference. I also made the hanger and cleats thicker. Because of that I can only recommend using your own settings. However, the total weight of 4 full spools is approximately 8.8 pounds. I made it so it could be printed on a 256x256 build plate. It also swivels left or right for easy spool access. Please keep in mind the length of the Boden Tube and AMS cable. This is depending how high you place the RepRack above the printer or how far away it is beside it. I recommend that if you are using an adapter sleeve on a spool please make sure it is a firm fit on the AMS Light.