Origin Story - Khay đựng linh kiện 3D (Sleeved, không hở nắp hộp)

Origin Story 3D Organization

I tremendously enjoy this game.  I wanted it sleeved. I designed this insert to fit Gamegenic Premium Sleeves with a few very small modifications.  Everything fits, but it is very tight. There is next to no box lift in mine. 

Sleeves: 

• I sleeved my game with all Gamegenic Premium Sleeves. 

• Playing Cards - Gamegenic Grey Size

• Event/Story/Vancardian Cards - Gamegenic Green Size

• Superhero Ref Cards - Gamegenic Magenta NOTE: I cut the top of these off to about 102.5mm to make them fit the card better. I use a straight paper cutter to do so. 

Notes: 

• Optional Magnets: I used 4 imbedded magnets to hold the Stamina Lid on the Stamina Box. I don't believe they are necessary, I just like to use them. 

  • Magnet Size: Round 4mm diameter x 2mm thickness

• The Holes in the Event/Solo box are meant to have the first player counter rest inside of them. without doing this, there is about 2mm of box lift. 

• This insert is very tight. It will compress your sleeves. 

• With as tight as this insert is, I wanted to offer some instructions for packing: 

  • OS_Event_Solo:

    • Small Side: All of the Event Cards and the 2 Player Aids for Solo Mode

    • 4x 1/2 cards for Solo and all remaining solo cards 

  • OS_HeartTokens:

    • All of the Stamina Tokens

  • OS_SH_Play_StoryCards:

    • Superhero Ref Cards

    • Playing Cards

    • Story Cards

Print the following for Organization:

1x OS_Event_Solo_v2

1x OS_HeartTokens_Bottom_v2

1x OS_HeartTokens_Top_v2

1x OS_SH_Play_StoryCards_v3

I designed this to be storable both flat on the bottom and sideways in a Kallax.

Noted Instructions:

It was Printed at .2 Layer Height. 15% Infill