Skip to main content
F3D
The Filter, Voron 2.4 - Bản mod sử dụng ngàm nam châm 1

3 images

Máy In 3D

The Filter, Voron 2.4 - Bản mod sử dụng ngàm nam châm

Remix of BỘ LỌC, cho Voron 2.4 By AKinferno

By lum0x_3113279

Downloads
106
Likes
21
Views
903

Files 5 1.1 MB

  • The-Filter-Mag-Mounted-Standard-Spacing_1776370691.stlSTL · 428.1 KB
  • The-Filter-Mag-Mounted-Side-Fan-Left_1776370694.stlSTL · 345.7 KB
  • The-Filter-Mag-Mounted-Side-Fan-Right_1776370696.stlSTL · 325.5 KB
  • The-Filter-Mount-A_1776370698.stlSTL · 28.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This is a mod of The Filter which removes the pogo-pin and allows mounting with standard 3x6mm N52 magnets. Wiring requires something like Molex Microfit connectors to allow the fans to be unplugged when removed.

Important: Only crimp the connectors after routing the wires following the suggested routing paths. Keep these wires relatively short (10cm or so) out of the back of the fans, but make sure to provide a good 10-15cm spare wiring under the bed so you can pull the fans out and disconnect the plugs.

BOM:

  • Center Fan
    • 8x 3x6mm N52 magnets
    • 1x The-Filter-Mag-Mounted-Standard-Spacing.stl
    • 1x The-Filter-Mount-A.stl
    • 1x The-Filter-Mount-B.stl
    • 2x M3x8mm BHCS
    • 2x M3 T-nut
  • Left Side Fan
    • 4x 3x6mm N52 magnets
    • 1x The-Filter-Mag-Mounted-Side-Fan-Left.stl
    • 1x The-Filter-Mount-A.stl
    • 1x M3x8mm BHCS
    • 1x M3 T-nut
  • Right Side Fan
    • 4x 3x6mm N52 magnets
    • 1x The-Filter-Mag-Mounted-Side-Fan-Right.stl
    • 1x The-Filter-Mount-B.stl
    • 1x M3x8mm BHCS
    • 1x M3 T-nut

Big thanks to the OG “The Filter” for the design.

Read more Show less

Print spec

Formats
stl
Model files
5
Total size
1.1 MB
Largest file
428.1 KB

0 comments

See all