Skip to main content
F3D
Giá đỡ cáp USB (USB Cable Holder) 1
Giá đỡ cáp USB (USB Cable Holder) 1
1 / 2

2 images

Đồ Gia Dụng

Giá đỡ cáp USB (USB Cable Holder)

By Nokedli_498597

Downloads
250
Likes
15
Views
677
Download all (.zip)· 2 files · 1.8 MB· 1.8 MB

Files 2 1.8 MB

  • USB_Cable_Holder_big_1776544661.stlSTL · 938 KB
  • USB_Cable_Holder_small_1776544663.stlSTL · 940.2 KB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#273495
Category
Đồ Gia Dụng
Published

Description

A holder for two USB charging cables.

The cable can snap into the holder so it doesn't fall out even during use. It can be pulled up for charging and then slides down into place again.

I attached it with double sided tape to the side of my table to always have my charging cable in one place.

Bigger Version:

Best fit with cables of diameter 3.5-4.0mm

Dimensions:
- hole diameters: 4.8mm/7.0mm
- slot width: 3.4mm (cable can snap in)

Smaller Version: (for thinner cables)

Best fit with cables of diameter around 3.0mm or less

Dimensions:
- hole diameters: 4.0mm/6.0mm
- slot width: 2.8mm (cable can snap in)

Filament: PETG (for some flexibility)

Designed to be printed on its flat side

EDIT: Added version for thinner cables, so that the snapping mechanism is still working.
The one shown on the pictures is the bigger version
Scale in slicer if you need a different size

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
1.8 MB
Largest file
940.2 KB

0 comments

See all

F3D uses essential cookies so the site works. Accept all also turns on marketing cookies for traffic and ad measurement; Essential only does not. You can change this in Cookie settings. Read the cookie policy