Tháp test flow nhanh - Không cần thước kẹp

Quick flow test. Better than Orca's tests in which it's hard to find that best block.

Set the base flow of the filament to 1. 
Print and match the C-shaped element to the towers. The elements must not be too loose. Don't force them in either. Target flow you can read from front number plus number of segments below. 

There are two towers. One from 90 to 100 and the other from 101 to 105. So the whole test is in the 90-105 range.

I have attached a 3mf file with settings for Orca Slicer. If you want to set the model on another slicer then you need to adjust the flow for each element. 
Base element : 1
Test blocks : 100 - ( 100 - value on block ) * 2
For example: 
for block 98, flow value 96
for block 104, flow value 108

Remember to print seam in the middle of the rounded corner, so that it does not falsify the results.

Print settings (default set in the file):
Layer height: 0.2
Width: 0.42